*MAXXD* Ollie's Nissan 200SX S14a

[OllieWestwood]

you have too mate

Problem solved!

Thanks Lee!

[liam-gtr]

nice work mate how far you planning on going with the engine mods

[OllieWestwood]

good question!

Id like to see the 300 mark

Id like to get the car to stage 1 then sort out some other touches i.e wheels spoiler suspension brakes then see where it goes

But id like a dyno of 300+ as an ultimate engine gain

[liam-gtr]

OllieWestwood;27486 Wrote:good question!

Id like to see the 300 mark

Id like to get the car to stage 1 then sort out some other touches i.e wheels spoiler suspension brakes then see where it goes

But id like a dyno of 300+ as an ultimate engine gain

nice 1.. sounds good, keep it up, hope it goes to plan for you matey

[Neil_S15]

OllieWestwood;27486 Wrote:good question!

Id like to see the 300 mark

My mates is 302bhp, 400nm torque, a lot of money has gone into it. Its the same colour as yours with chrome bay if you remember from LSOM few months ago

[piman2k]

Not Ian by any chance aka big_dude?

[IIvIIitch]

did you make it to the sxoc meet?

[Roger_Sausage]

300bhp is a doddle mate, my car at H-Dev stage 2 with an uprated actuator made 318bhp @ the fly and 288 @ the wheels on seperate RR's. I toasted the clutch within about a fortnight of getting it sorted though!

Ian's car's awesome looking under the bonnet!

[piman2k]

Aye, let me dig out some pictures. Ahhhh balls, here's loads here ha ha ha ha!!!

[Neil_S15]

piman2k;28125 Wrote:Not Ian by any chance aka big_dude?

That would be the 1!He calmed down with the modifying too much since he met the new wife, only mods since her are baby seat in rear and bung in exhaust!