*MAXXD* Pyro's Subaru Impreza Bugeye

[Alanman]

Depending on what happens when you undo the nuts, denotes what you need to do.

If the bumper stays in position with all the bolts undone, then I'd say ALL you need is the clips on the side. Bigcab's front bumper is vertually like that now. The only bolts fastened are the ones to the wings (where those clips go).

The most likely scenario will be the bumper dropping lower at the front once you undo the bolts in the middle. If it does, then you'll need to work out how to stop this. The holes that the bumper goes through will be elongated to allow for slight adjustment up and down. One option would be to sleave the bolts to make them the same size as the holes and no adjustment. Or spots of weld to make the holes smaller.

I think its easily done but probably one of those job you cant say until you start.